Pages

Sunday, September 5, 2021

Performing the Initial Setup of the Citrix FAS Administration Console fails at Authorize this service with: "Failed to Issue certificate: CR_DISP_DENIED (code 2)"

Problem

You’re attempting to set up a Citrix Federated Authentication Service server to allow using Azure AD authentication with single sign-on but the configuration fails at the Authorize this service with the error:

The authorization request on <CertServerFQDN>\<CA Name> failed: Failed to Issue certificate: CR_DISP_DENIED (code 2).

image

Reviewing the Certification Authority management console’s Pending Requests does not show the expected pending request and reviewing the Failed Requests show the FAS server request being denied:

image

image

Request Status Code: The requested certificate template is not supported by this CA. 0x80094800 (-2146875392)

Request Disposition Message: Denied by Policy Module 0x80094800, The request was for a certificate template that is not supported by the Active Directory Certificate Services policy: Citrix_RegistratrionAuthority_ManualAuthorization.

Attempting to manually enroll from the certificates console for the certificate also fails:

image

Solution

One of the reasons why the authorization of the FAS server would fail is if the permissions for the Citrix_RegistrationAuthority_ManualAuthorization template is not configured properly. Begin by launching the Certificates Templates Console on the CA that the FAS server is attempting to be authorized and open the properties of the Citrix_RegistrationAuthority_ManualAuthorization template:

image

Navigate to the Security tab and verify that the Authenticated Users group has Read permissions:

image

Domain Computers has Read and Enroll:

image

With the required permissions in place, attempt to authorize the server again and the status should now display:

There is a pending authorization request on CertServerFQDN>\<CA Name>.

image

Navigate into the Certification Authority management console’s Pending Requests and you should now see the following pending request:

The operation completed successfully. 0x0 (WIN32:0)

image

Proceed to authorize the pending request and the Authorize this service step should now complete:

image

2 comments:

Unknown said...

Excellent post..keep up good work sir.

Cmptrmaster said...

I received this exact same error when trying to authorize the service. I checked permissions and they were as you noted in this article. Authorization still fails with the same error