tag:blogger.com,1999:blog-2228947945609574437.post8706468155247048839..comments2024-03-17T16:23:31.499-04:00Comments on Terence Luk: Problem with initial Cisco UCS 6100 series fabric interconnect setup with error message: “Failed to configure given password on the switch, system will be rebooted , please wait… !”Terence Lukhttp://www.blogger.com/profile/02612575579652280306noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-2228947945609574437.post-27042713536996047672011-08-17T14:55:07.605-04:002011-08-17T14:55:07.605-04:00The reason why I chose standalone was because I ha...The reason why I chose standalone was because I had problems setting up the cluster and during the troubleshooting process, I decided to just configure the first node as a standalone then add the secondary FI to build a cluster. You could do it either way but I just wanted to eliminate any factors that may be causing my problems.Terence Lukhttps://www.blogger.com/profile/02612575579652280306noreply@blogger.comtag:blogger.com,1999:blog-2228947945609574437.post-86437267715331385772011-08-17T14:44:28.828-04:002011-08-17T14:44:28.828-04:00Hi Terence,
I did this back when you did it goin...Hi Terence,<br /> I did this back when you did it going from 1.31c to 1.41i for the same reason. Why in heaven's name did you make the FINs standalone rather than leaving them in a cluster (not criticizing so much as curious)? Also interested in what you ran into when doing the upgrade. I've since gone to 1.42b and am now at 1.43lucscrazyhttps://www.blogger.com/profile/17354591632832912028noreply@blogger.com