tag:blogger.com,1999:blog-2228947945609574437.post1554304453268785332..comments2024-03-17T16:23:31.499-04:00Comments on Terence Luk: Cisco UCSM Error: “Failure re-acknowledging Slot #. Cause: Slot identity is being established. Try again later".”Terence Lukhttp://www.blogger.com/profile/02612575579652280306noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-2228947945609574437.post-62360425347186415182016-12-16T18:08:03.659-05:002016-12-16T18:08:03.659-05:00Appropriate/Supported way before moving blade acro...Appropriate/Supported way before moving blade across or same chassis is to <br />1. Dis-associate the Service profile.<br />2. Decommission the Blade.<br />3. Move to the slot in the same or different Chassis as per your need.<br />4. Accept the Blade in the Slot.<br />5. Associate the Service-Profile.Rajesh Sababhathinoreply@blogger.comtag:blogger.com,1999:blog-2228947945609574437.post-52416066328796424032016-09-12T21:28:12.721-04:002016-09-12T21:28:12.721-04:00I know this is an old post but I have a question i...I know this is an old post but I have a question in regards to the moving of a blade from slot to slot. Can you just powerdown and move or should you powerdown, dissaccociate the profile, decomm the server, move the server, apply profile?Anonymoushttps://www.blogger.com/profile/10493515172034658391noreply@blogger.comtag:blogger.com,1999:blog-2228947945609574437.post-35224356684740141142011-01-22T19:11:24.479-05:002011-01-22T19:11:24.479-05:00Thanks for your comment Harold. It's great to...Thanks for your comment Harold. It's great to hear that this post helped in some way and it's even better that you added your input in your comment that may end up helping me in the future. Thanks again.Terence Lukhttps://www.blogger.com/profile/02612575579652280306noreply@blogger.comtag:blogger.com,1999:blog-2228947945609574437.post-2360499635628048312011-01-21T11:29:47.018-05:002011-01-21T11:29:47.018-05:00Had the same issue on a B250 M1 bladed this week. ...Had the same issue on a B250 M1 bladed this week. Tried acknowledging AND decommissioning/commissioning the chassis and neither worked. To fix the issue I had to shutdown the entire system, and then click the "here" link in the popup message once things got back online to successfully re-acknowledge the blade. Thanks for posting this as it put us in the right direction.Haroldhttp://haroldsimon.blogspot.comnoreply@blogger.com